Laura Ashley PXC233 Instruction Manual download pdf

1. Take out the socket with cord, thread the cord

through the center hole of the rack, cover, cap

nuts, canopy and two holes of the strain relief.

2. Attach the socket to the top end of the rack by

inserting the nipple, secure it with the cover

and cap nut.

3. Measure the desired length of the cord (A)

from the canopy to the cap nut and leave an

additional 9" of cord (B) above the canopy

(include the canopy). Then cut off the

unnecessary cord. (See Fig.1)

4. Adjust strain relief a 9" position from the top

of the cord.

5. Mark the 3" of cord (C) from the top of the

cord (B). Use a knife to peel off the insulation

of the cord (C) carefully to expose the 3 wires

on the inside. (See Fig.1)

Caution: Cutting too deep may cut off the three inside

wires and destroy the insulation surface of the three

inside wires.

6. Peel off the 3 wires from the top about 3/8" long(D) to

expose the copper for wiring.

7. Attach the mounting strap to the outlet box by using two

mounting screws.

8. Pull out the outlet wires and the house grounding wire from

the outlet box. Make wire connections using the wire nuts:

a. The clear wire marked "L" from the fixture to the black

wire from the power source.

b. The clear wire with white line and marked "N" from the

fixture to the white wire from the power source.

c. The clear grounding wire with green line and marked

" " from the fixture to the green grounding wire from

power source.

Carefully put wires back into the outlet box.

9. Pull the cord ( A ) down slightly until the strain relief touches

the hex nut. Then gently secure the plastic screws. Do not

over tighten.

Note: Adjusting the strain relief and plastic screw of the

canopy can decrease or increase the length of cord that

is exposed.

10. Attach the canopy to the mounting strap. Lift the canopy, allowing

the two screws and washers to slide into the mating slots. Rotate

the canopy clockwise until both screws from the mounting strap

drop into the slot recesses. Tighten screws securely.

11. Install a bulb (not included). See relamping label at socket

area or packaging for maximum allowed wattage.

12. Turn on the power at the main fuse or circuit breaker box.

Canopy

Outlet Box

Mounting Strap

Washer

Screw

Mounting Screw

Wire Nut

C(3")

D(3/8")

B(9")

FIG.1

Strain Relief

Hex Nut

Plastic Screw

Cover

Cap Nut

Nipple

Socket

Rack

Cord

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Read and save this instruction.

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Assembly Instructions

Daliya Capiz Pendant # PXC222 / PXC233 / PXC244

1 2

Assembly Instructions 1

Summary of Contents

Page 1 - Assembly Instructions

1. Take out the socket with cord, thread the cord through the center hole of the rack, cover, cap nuts, canopy and two holes of the strain re

Page 2

1.) If any strand of capiz has broken discs, remove the strand of capiz.2.) Decide the length of spare strand of capiz and cut off unwanted

Comments to this Manuals

No comments

Laura Ashley PXC233 Instruction Manual

Browse online or download Instruction Manual for Unknown Laura Ashley PXC233. Laura Ashley PXC233 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Laura Ashley PXC233